$ 10.00 USD
Heavy Duty Die Cut Vinyl Sticker - 11" wide - perfect for your car's rear window!
Application Directions:
1) Lay decal FACE UP on a smooth hard surface. Squeegee
the surface to insure good contact between the pre-mask and the vinyl beneath
it.
2) Lay decal flat, FACE DOWN. Slowly remove backing paper
from the pre-mask, pulling straight back and flat (not at an angle).
3) Apply pressure-sensitive vinyl to prepared (cleaned
and dried) surface, then squeegee pre-mask surface using overlapping
strokes.
4) Pull pre-masking away at an angle using a continuous
motion. If bubbles occur in the letters, simply prick with a needle and smooth.
Do not use a knife or razor.
Subscribe to our newsletter and always be the first to hear about what is happening.
© 2024 Bandwear. com 2025 Midway Rd. Suite C Carrollton, TX 75006
